Introduction to Gas Deposition Furnace: Rotary furnace has the advantages of simple operation, safety and reliability, high temperature control accuracy, good insulation effect, large temperature range, high furnace temperature uniformity, multiple temperature zones, optional atmosphere, and vacuum furnace type. During the use of the rotary furnace, installation is a very important step, which will directly affect the later use of the rotary furnace. Below, let's learn about the gas deposition furnace:
<
1. When installing the rotary furnace: There are no special requirements. On the indoor ground or platform, the electric furnace controller should be placed on the workbench, with a tilt of no more than 5 degrees. The controller should be at least 0.5 meters away from the laboratory electric furnace. To ensure the normal operation of the controller, the controller should not be placed on the electric furnace.
2. When wiring, first loosen the screws on the left and right sides of the controller shell, and then flip the cover up and connect it.
After installing the power cord, connect the controller to the electric furnace and the thermocouple connection wire. Insert the thermocouple into the furnace through the small hole in the thermocouple fixing seat, and block the gap between the hole and the thermoelectric with asbestos rope before fixing it After checking the wiring, the power can be turned on. Then, turn on the switch on the rotary furnace controller panel, adjust the setting button, and set the temperature to the desired degree. If the setting switch is turned to the measurement position, the red light goes out, and there is also a sound of the contactor closing. The electric furnace is powered on, and the ammeter indicates the heating current value. The temperature gradually increases with the temperature inside the furnace, indicating normal operation. The above introduction to the vapor deposition furnace is hoped to be helpful to everyone.